Remington MB4110 Mode D'emploi page 5

ENGLISH
ATTACHING AND REMOVING THE HEADS
To attach or remove the heads press the red release button at both sides of the product.
TO THIN AND TAPER THE BEARD/MOUSTACHE (DIAGRAM 1)
Attach a guide comb to the 38mm Trimmer-Blade. If you are trimming for the first time start
with the maximum trimming length setting.
Turn the unit on.
Place the flat top of the trimmer comb against the skin.
Slowly slide the personal groomer through the hair. Repeat from different directions as
necessary.
If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off
the comb and brush/rinse off.
TRIMMING EDGE OF SIDEBURNS (DIAGRAM 2)
Hold the personal groomer with 38mm Trimmer-Blade facing you.
Start with edge of sideburn, and with the trimmer blades resting lightly against your skin, use
motions towards edge of sideburn line to trim to desired locations in facial area.
USING THE SHAVER (DIAGRAM 3)
Attach the shaver.
Use short, well-controlled movements. Use your free hand to stretch your skin. This
encourages the hair to stand upright, making it easier to shave.
NOTE: Always trim your facial hair first before shaving.
Tips for best results
Beard, moustache and sideburn hairs should be dry.
Avoid using lotions before using your personal groomer.
CLEANING AND MAINTAINING YOUR PERSONAL GROOMER
AFTER EACH USE
1.
2.
CLEANING CAUTIONS
Only use the light-grade oil supplied or sewing machine oil on the blades.
Do not use harsh or corrosive cleaners on the units or their blades.
Do not submerge in water as damage will occur.
100595_REM_IFU_MB4110_21L.indd 3 100595_REM_IFU_MB4110_21L.indd 3
CARE FOR YOUR PERSONAL GROOMER
Turn the personal groomer off.
Gently brush the remaining hairs away/rinse under warm water from the guide comb and
trimmer blade.
3
12.08.10 20:59 12.08.10 20:59