3.3.7
Reprogramming the configuration
The factory default configuration is as follows:
Function
Sensitivity level
Alarm Delay
Alarm Latch
Automatic BIT
Alarm BIT
Heat Mode
Temperature
(41 °F)
RS-485 address
1)
Auxiliary BIT
1)
Auxiliary Relay
1)
only available in wiring option 4 and 5
Default value for
15
30
40
A
A
A
no
no
no
yes
yes
-
no
no
-
auto
auto
auto
5 °C
5 °C
5 °C
(41 °F)
(41 °F)
(41 °F)
1
1
1
no
no
-
no
no
no
Using either the RS-485 interface or the HART protocol, you can
reprogram the following parameters:
Sensitivity level
Alarm delay
Address setup
Mode of operation
Heat mode
To change the configuration parameters the following accessories are
required:
Dräger Flame USB RS-485 Kit and corresponding manual:
The harness kit with RS-485/USB converter, used with the host
software, enables you to connect to any available PC or laptop to
reconfigure settings or perform diagnostics on all Dräger
30
Flame 2xx0 detectors.
Possible sensitivity levels
A
Dräger Flame 2000 offers 2 different sensitivity levels. Dräger
no
Flame 2500/2570/2700 offer 4 different sensitivity levels. For more
yes
information on the detector sensitivity, see chapter 7.4 on page 22.
no
auto
5 °C
1
no
no
en
Use
13