Before Fi Rst Use; Assembling The Appliance - SilverCrest SSK 300 A1 Mode D'emploi

WARNING!
GB
THERE IS A RISK OF INJURY!
IE
► Overfi lling the blender jug can lead to hot
liquid splashing out during food preparation!
Risk of scalding! Always pay attention to the
markings on the blender jug!
► Always remove the lid carefully, opening it
facing away from you so that steam can
escape towards the rear. Do not lean over
the appliance while it is boiling. Use a dish
cloth or oven gloves when touching the lid
and the blender jug.
Caution! Hot surface!
ATTENTION! RISK OF FIRE!
► Do not operate the appliance in the vicinity
of or under curtains, wall-mounted cupboards
or other fl ammable materials.
► Place the appliance on a heat-resistant surface
(not on varnished tables or tablecloths). Do not
operate it close to other heat sources (cooker,
gas fl ame). Otherwise there is a danger of
damage to the appliance and/or furniture.
► Place the appliance on a level and stable
surface. Ensure that it is set up at a suffi cient
distance to walls and cupboards. This will
ensure that you avoid damage caused by
rising steam.
► Never operate the appliance via an external
time-switch or a separate remote control system.
ATTENTION! DAMAGE TO PROPERTY!
► Never operate the appliance when it is empty,
in other words, without any ingredients in the
blender attachment.
4
Before fi rst use
■ Remove all packaging materials from the appli-
ance.
■ Clean the appliance as described in the section
"Cleaning and Care".
■ Ensure that all parts are completely dry before
operating the appliance.

Assembling the appliance

NOTE
► The appliance cannot be switched on until all
parts are correctly assembled.
1) Place the measuring cup 1 in the lid 2 so
that the two plastic tabs on the measuring
cup 1 fi t into the notches on the lid 2.
2) Turn the measuring cup 1 clockwise a little
way so that it sits tightly.
3) If required, place the puree fi lter 9 centrally
above the blade 4.
4) Place the lid 2 slightly off set on the blender
jug 3 (the arrow on the handle points to the
opened lock ). Now turn it until the catches
on the lid 2 engage in the grooves on the blend-
er jug 3 and click fi rmly into place (the arrow on
the handle points to the closed lock
2 also fi xes the puree fi lter 9 into place.
5) Place the blender jug 3 on the motor block 5
so that the contacts on the blender jug 3 con-
nect with the sockets on the motor block 5
(when the mains plug is connected, the cor-
rect placement of the blender jug 3 will be
confi rmed by a signal tone).
NOTE
Place the egg insert 7 as far as it will go into
►
the blender jug 3 until it is fi rmly in place. The
handle of the egg insert 7 will be pointing
upwards.
).The lid
SSK 300 A1