Bosch PSB 14,4 V-i Mode D'emploi page 13

Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the provisions of the directives 89/336/EEC,
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Assembly
Battery Charging
A battery that is new or has not been used for a longer
period does not develop its full capacity until after
approx. 5 charging/discharging cycles.
To remove the battery 6 press the unlocking buttons 7
and pull out the battery downwards. Do not exert any
force.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery serv-
ice life is achieved in this manner.
A significantly reduced working period after charging
indicates that the battery is used and must be replaced.
Observe the notes on environmental protection.
2 609 932 356 • 22.4.04
Dr. Eckerhard Strötgen
Head of Product
Certification
Auxiliary Handle
Operate your machine only with the auxiliary
handle 10.
The auxiliary handle 10 can be set to any position for a
secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxiliary
handle 9 in anticlockwise direction and set the auxiliary
handle 10 to the required position. Then tighten the
wing bolt 9 again in clockwise direction.
Adjusting the Drilling Depth (see figure A)
The required drilling depth X can be set with the depth
stop 11.
Press the button for the depth stop adjustment 8 and
insert the depth stop into the auxiliary handle 10.
Pull out the depth stop until the distance between the
tip of the drill bit and the tip of the depth stop corre-
spond with the desired drilling depth X.
Changing the Tool (see figure B)
Before any work on the power tool, remove the
battery.
Tightly hold the rear sleeve of keyless chuck 1 and turn
the front sleeve anticlockwise until the tool can be
inserted. Insert the tool.
Tightly hold the rear sleeve of the keyless chuck 1 and
firmly turn the front sleeve clockwise by hand until the
locking action is no longer heard. This automatically
locks the drill chuck.
The locking is released again to remove the tool when
the front sleeve is turned in the opposite direction.
Screwdriver Tools (see figure C)
When using screwdriver bits 12, a universal bit
holder 13 should always be used. Use only the screw-
driver bits that fit the screw head.
For screwdriving, always set the "Drilling/Impact Drill-
ing" selector switch 2 to the "Drilling and Screwdriving"
symbol.
English–4