Charging The Lift Unit - Handicare RiseBasic300M Mode D'emploi

Charging the lift unit

RiseBasic can be used with three different charging systems:
1. Charger station for charging via hand control (standard version)
2. In-rail charging (accessory)
3. End-point charging (accessory)
RiseBasic is charged with a charger unit that is connected to the charger cables via a DC outlet. The charger should be
kept in an appropriate location. Note that the charger is a separate unit and can be easily mistaken for another charger.
Ensure that the correct charger is used, see Technical information. For assembly instructions, see Assembly of charger
unit.
1) The lift unit is charged via a wall-mounted charger station. Place the handset in the
charger station. The charging lamp on the lift unit indicates charging for four minutes
after being activated. Charging continues until the battery is fully charged.
2) For in-rail charging, the lift unit is always being charged, which means that it can
be left anywhere on the rail and will charge automatically.
3) For end-point charging, the lift unit is placed at the charger station at the end of
the rail. If the rail system is of the traverse type, the secondary rail is placed at the
end of the primary rail at which the charger station is located. Check to ensure that
the battery symbol on the lift unit lights up.
SystemRoMedic 11
M A N U A L
TM