Hitachi DS 14DSAL Instructions De Sécurité Et Mode D'emploi page 15

NOTE
A buzzing noise is produced when the motor is
about to rotate; this is only a noise, not a machine
failure.
10. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
When using the hook, hang up the power tool
firmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
When carrying the power tool with hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it with hooked to your
waist belt, you will be injured.
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Removing the hook.
Remove the screws fixing the hook with Philips
screw driver. (Fig. 10)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fix the hook firmly.
(Fig. 11)
Work
Wood
Drilling Steel
Aluminum
Small
screw
Screw
Wood
tightening
screw
Screw
Hook
Fig. 10
Clutch dial position
1 – 22
1 –
11. Using the light
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 12)
Light
Trigger switch
CAUTION
Do not look directly into the light. Such actions
could result in eye injury.
12. The scope and suggestions for uses
The usable scope for various types of work based
on the mechanical structure of this unit is shown
in Table 5.
Table 5
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
Screw
Hook
Fig. 11
Fig. 12
Suggestions
English
15