Safety Instructions For Maintenance; Operation - Husqvarna K1270 II R Manuel D'utilisation

can loosen it and cause leakage of fuel and fuel
fumes. Fuel and fuel fumes are a risk of fire.
• Before you start the product, move the product to a
minimum of 3 m/10 ft from where you refueled.
Min
• Do not start the product if there is fuel or oil spilled
on the product. Remove the unwanted fuel and oil
and let the product dry before you start the engine.
• Examine the engine for leaks regularly. If there are
leaks in the fuel system, do not start the engine until
the leaks are repaired.
• Keep fuel in approved containers only.
• When the product and fuel is in storage, make sure
that fuel and fuel fumes cannot cause damage, fire
and explosion.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life. This
fuel contains less harmful chemicals compared to
regular fuel, which decreases harmful exhaust
1390 - 001 - 10.01.2020
• Drain the fuel in an approved container outdoors and
away from sparks and flames.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product.
• Make sure that the engine is off and that the stop
switch is in STOP position.
• Use personal protective equipment. Refer to
Personal protective equipment on page 4 .
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Let an approved Husqvarna service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
• Always use original accessories.

Operation

fumes. The quantity of remains after combustion is
lower with this fuel, which keeps the components of
the engine more clean.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
US fl. oz.
2 ½
6 ½
12 ⅞
7