Husqvarna K1270 II R Manuel D'utilisation page 16

3. Pull out the starter rope (A).
A
C
B
4. Put your thumb on the starter pulley (B) to keep the
starter rope pulled out.
5. Release the starter rope from the notch (C).
6. Remove your thumb to release the starter pulley (A)
and let the starter rope (B) wind up on the pulley.
7. Pull out the starter rope fully to do a check that the
recoil spring is not at its end position. Make sure that
the starter pulley can be turned half a turn or more
before the recoil spring stops the movements.
To remove the spring assembly
WARNING: Always use eye protection when
you disassemble the spring assembly. There
16
B
B
A
is a risk for eye injury, especially if a spring
is broken.
1. Remove the bolt in the center of the starter pulley
and remove the starter pulley. Carefully remove the
cover.
The recoil spring has tension in the starter housing.
2. Carefully remove the spring. Use a pair of pliers.
To lubricate the spring assembly
• Lubricate the recoil spring with light oil.
To attach the spring assembly
• Assemble in the opposite sequence of
the spring assembly on page 16 .
To remove
1390 - 001 - 10.01.2020