Connections - Aiwa NSX-DS8 Mode D'emploi

PREPARATIONS

CONNECTIONS

Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is
120 V AC. Check that the rated voltage matches your local
voltage.
1
Connect the right speaker to the main unit.
1 Connect the speaker cord with the plug to the
SPEAKERS HIGH FREQ R terminal.
2 Connect the speaker cord with the white stripe to the
SPEAKERS LOW FREQ R 0 terminal and the black
cord to the 9 terminal.
NOTE
• Be sure to connect the speaker cords correctly. Improper
connections can cause short circuits in SPEAKERS terminals.
4
ENGLISH
IMPORTANT
Connect the speakers, antennas, and all optional equipment first.
Then connect the AC cord.
2
Connect the left speaker to the main unit.
Connect the speaker cord with plug to the SPEAKERS HIGH
FREQ L terminal, and the other speaker cord to the
SPEAKERS LOW FREQ L terminals in the same manner
as step 1.
3
Connect the surround speakers.
Connect the surround speaker cords to SURROUND
SPEAKERS terminals.
4
Connect the center speaker.
Connect the center speaker cord to CENTER SPEAKER
terminal.