Aiwa NSX-DS8 Mode D'emploi page 5

POSITIONING THE SPEAKERS
To achieve the optimum effects obtainable with the Dolby
Digital or the Dolby Pro Logic system, it is important to position
the speakers properly. Refer to the following illustration to
find out the best location in your room.
5
Connect the supplied antennas.
Connect the FM antenna to FM 75 Ω terminals and the AM
antenna to AM LOOP terminals.
AM antenna
6
Connect your video equipment (DVD player, LD
player, video tape player, etc.).
If your video equipment has an OPTICAL OUT jack ;
Connect the AUDIO OUT jacks of the video equipment to
the VIDEO1/DVD/AUX jacks of this unit with an optional
audio connecting cord with RCA phono plugs (red plug to
the R jack, white plug to the L jack).
Connect the OPTICAL OUT jack to the DIGITAL IN OPTICAL
(VIDEO 1) jack of this unit with an optional optical connecting
cord.
If your video equipment has a COAXIAL OUT jack ;
Connect the AUDIO OUT jacks of the video equipment to
the VIDEO2/LD/MD jacks of this unit with an optional audio
connecting cord with RCA phono plugs (red plug to the R
jack, white plug to the L jack).
Connect the COAXIAL OUT jack to the DIGITAL IN
COAXIAL (VIDEO 2) jack of this unit with an optional coaxial
connecting cord.
L&R: Front speakers
C: Center speaker
Position in the center of the two front speakers. In addition,
position on or below the TV set, if connecting a TV set to the
unit.
LS&RS: Surround speakers
Place the surround speakers directly to the side of or slightly
behind the listening area. Align them horizontally, about 1
meter (3.2 feet) above ear height.
NOTE
Sound output from the center and the surround speakers is
only available when the Dolby Digital system, the Dolby Pro
Logic system, or the DSP Surround system is activated with
the appropriate setting.
To mount the surround speakers on the wall
Mount each speaker on a spot that can hold its weight.
FM antenna
7
8
NOTE
• Input to the DIGITAL IN OPTICAL jack is selected with
the VIDEO1/DVD/AUX button, while input to the DIGITAL
IN COAXIAL jack is selected with the VIDEO2/LD/MD
button (see "Listening to external equipment", page 32).
Analog connection should thus be made to the input jacks
with the corresponding names depending on the type of
digital connection, as described above.
The illustration shows the connection to the VIDEO1/DVD/
AUX jacks.
• If your video equipment has both OPTICAL and COAXIAL
OUT jacks, choose either connection.
• When connecting an LD player via its AC-3 RF OUT jack,
use an RF demodulator to separate the analog visual
signals and the digital audio signals. Refer the operating
instructions of the LD player.
If your video equipment does not have a digital out jack ;
Connect the AUDIO OUT jacks of the video equipment to
the VIDEO1/DVD/AUX jacks of this unit with an optional
audio connecting cord with RCA phono plugs (red plug to
the R jack, white plug to the L jack).
Connect the television to the video equipment.
Refer to the Operating Instructions of the connected
equipment for details.
Connect the AC cord to an AC outlet.
The DEMO will begin when the AC cord is plugged into an
AC outlet for the first time. To deactivate the DEMO, set the
clock.
En
5
ENGLISH