Publicité
9
Restart Windows.
Next, you will need to make the driver settings.
(
Settings and checking (p. 36))
Windows 98 users
The USB composite device driver is installed first, then the
USB audio device driver is installed. Use the following
procedure to install the drivers.
1
With the UA-20 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB
mouse (if used).
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
3
Set the UA-20's ADVANCE (mode select) switch to
the OFF position.
4
Use a USB cable to connect the UA-20 to your
computer.
fig.05-25e_30
5
USB composite device
will be detected
automatically, and the
"Add New Hardware
Wizard" dialog box will
appear. Click [Next].
Getting Connected and Installing Drivers (Windows)
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
If this dialog box does not
appear, refer to "Find new
hardware wizard" does not
execute automatically (p. 66).
33
Publicité
