Publicité
Getting Connected and Installing Drivers (Windows)
8
Use the USB cable to connect the UA-20 to your
computer.
fig.05-15e_30
9
If you are using
Windows 98, an
Insert disk
dialog box will
appear.
Click [OK].
fig.05-16e_30
10
The New Hardware
Found dialog box will
appear.
In the Copy files from
field, type the folder name
that is shown in the
SetupInf dialog box, and click [OK].
D:\DRIVER\USB_ME98
* The drive name "D:" may be different depending on your system.
Type the name of your CD-ROM drive.
11
Once the driver has been installed, the New Hardware
Found dialog box will close.
In the SetupInf dialog box, click [OK]. The SetupInf dialog
box will close.
Next, you need to make the driver settings.
(
Settings and checking (p. 36))
30
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
If you are using Windows 98
and the Insert disk dialog box
dose not appear, please read
The "Insert Disk" dialog box
does not appear (p. 68).
If the New Hardware Found
dialog box does not appear, re-
install the driver using the
same procedure as described
in The "Insert Disk" dialog
box does not appear (p. 68).
Publicité
