Important Safety Instructions - Newa Pond Pure light UV-C Advance Mode D'emploi Et Garantie

EN Operating Instructions
Contents
I. IMPORTANT SAFETY INSTRUCTIONS
II. NAME OF COMPONENTS
III. INSTALLATION
III.a. Assembling of connecting parts
1. pump --> UV-C filter
2. UV-C filter --> pond pump
III.b. Fixation of filter to fixed support
IV. PERFORMANCE
IV.a Switching on/off
V. MAINTENANCE
V.a. Assembling / Replacement of UV-C lamp
V.b. Quartz tube cleaning
V.c. Replacement of filter head O-ring
VI. TROUBLESHOOTING
VII. PROPER DISPOSAL
VIII. GUARANTEE CONDITIONS
SPARE PARTS
I.

IMPORTANT SAFETY INSTRUCTIONS

The present appliance is a filter with the function of sterilization by means of short-wave ultraviolet radiation lamp UV-C,
intended for outdoor use in freshwater decorative ponds and indoor use in freshwater or salt water aquariums. Any other use
is not permitted and therefore the manufacturer shall not be held liable. PURE LIGHT UV-C complies with current EU safety
regulations EN 60335-2-109.
WARNING: the current symbol on the product label indicates that it is necessary to carefully read this operating instruction
manual before operating, using and carrying out maintenance on the appliance.
To avoid any kind of accident, carefully follow the simplest safety provisions and the following warnings:
1) WARNING: this appliance cannot be used by children under eight or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instructions concerning use of the appliance in a safe way and understand the risks
involved. Children shall not play with the appliance because this is not a toy. Cleaning and maintenance
shall not be made by children without supervision.
2) WARNING: disconnect all submerged electrical appliances in the pond (or in the aquarium) before
carrying out installation and maintenance operations. If the connection plug or the electric socket
should be wet, disconnect the master switch before pulling out the power supply cable.
3) The power cord cannot be repaired. If it is damaged, the entire appliance should be discarded, or the
power cord should be replaced by a cord of the same kind. BUT THIS OPERATION MUST BE PERFORMED
BY QUALIFIED PERSONNEL ONLY.
4) This appliance must be supplied through a residual current device (RCD) having a rated residual
current not exceeding 30mA (Idn ≤ 30 mA).
5) WARNING: this appliance contains an emitter with UV-C rays, which may damage the eyes and skin.
Improper use or damage to their protective casing may cause harmful UV-C radiation to leak out. If
clearly damaged, the appliances must not be used.
6) WARNING: it is prohibited to use the UV-C lamp on the outside of the appliance.
13
pag. 13
pag. 14
pag. 15
pag. 15
pag. 15
pag. 16
pag. 16
pag. 16
pag. 16
pag. 17
pag. 17
pag. 48
EN