Elem Garden Technic TRE2042SO Instructions D'origine page 37

Kick-back causes the saw to behave uncontrollably
and thus brings with a slack or blunt chain.
A poorly sharpened chain increases the risk of kick-
back. Never saw above shoulder height.
OPERATION - TIPS ON CHAIN SAW
USE
Sawing blocks
_ If possible, always use a saw horse.
_ Always start a cut with the chain running
and the serrated fender against the wood.
_ Rotate the serrated fender against the
wood to complete a cut.
The way of sawing depends on the way the
block is being supported.
Full-length support (the block is on the
ground):
_ Make a vertical cut downwards.
_ Make sure that you do not touch the ground.
Support at both ends (the block is on the
saw horse):
_ Make a vertical cut downwards to one
third of the longitudinal section.
_ Rotate the block and lay it on the saw
horse with the cut pointing downwards.
_ Make a second cut towards the first cut.
Support at one end (the block is on the saw
horse):
_ Make a vertical cut downwards.
Sawing trees
_ Make a horizontal cut to one third of the
diameter of the trunk. Subsequently make
a diagonal cut at a 45° angle from top to
bottom so that a notch is created.
_ Make a cut on the other side, but make
sure that you do not saw through the notch.
_ Place a wedge in the cut to make an
opening and drop the tree.
Felling trees is dangerous and
requires practice. If you are a
beginner or inexperienced, do not
try to teach yourself but seek
professional training.
CLEANING AND MAINTENANCE
Always pull the plug out of the
power socket before doing any
Keep the cooling vents on the motor housing
clean and unobstructed at all times.
Only the maintenance work described in these
operating instructions may be carried out. Any other
maintenance work must be carried out by our
Customer Service.
Do not modify the power saw in any way as this
could jeopardize its safety.
Should the chainsaw fail despite our careful
manufacturing and inspection procedures, have it
repaired by an authorized Customer Service work-
shop.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
Motor Speed min-1
No load speed m/sec
Bar length
cutting length
Chain brake time ms
Oil container capacity ml
Weight kg
Acoustic pressure level
LpA 85.9 dB(A) K = 3 dB(A)
Acoustic power level
LwA 105,9 dB(A) K = 2.36 dB(A)
Garantee : LwA 112 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard.
8.393 m / s ²
Main Handle:
Auxiliary handle: 6.002 m / s ²
K = 1.5 m / s ².
37
work on the chainsaw!
230-240
50
2000W
7000
12.1
16'' 406mm
355mm
< 0.12 sec
280ml
5kg
ATTENTION !
must be worn.