Installation Procedure - Kenwood LZH-70W Manuel D'installation

Installation procedure

Note: The following description is for a standard installa-
tion. It may have to be adapted to suit your vehicle. For
queries relating to installation procedures and/or mount-
ing hardware, please contact your dealer or a company
offering equivalent components. Kenwood recommends
having a qualified technician install the monitor.
1. Determine the mounting location for the console.
• The mounting location is differed depending on the
vehicle's type.
• Ensure that when opened, the monitor will not obstruct
the driver's rear view.
• Remove the vehicle's overhead console and dome lamp if
they interfere with the console.
2. Apply masking tape to the headliner and mark the
console's mounting location.
• Use the included template as a guide.
3. Using the included template as a guide, cut the wire
access hole in the headliner.
4. Once the access hole is cut in the headliner, use a mark-
ing pen to trace the outline of the hole on the inside of
the vehicle's roof.
5. Carefully remove the headliner.
• Before you begin make sure the headliner is not glued-in.
• Remove visors, consoles, handles, pillar covers, and
anything that attaches the headliner to the vehicle.
• Make sure not to crease the headliner.
6. Mark the console's location on the inside of the roof:
a) Align the access hole in the template with the one you out-
lined on the roof.
b) Tape the template to the roof, making sure that it is prop-
erly aligned with the vehicle's centerline.
c) Use a marking pen to trace the outline of the template on
the inside of the roof.
7. Prepare bracket to install the console.
• Length: Adjust to the length of crossmember
• Wide: 190 mm
• Thickness: More than 9 mm
8. Fix the bracket to the console's location marked inside
of the roof.
• Make sure screws are the correct length to avoid
damaging the vehicle roof.
4
Step 2: Marking the mounting location on the headliner
Step 7: Preparing the bracket
Guide Marks on Roof
Mounting Screws
Step 8: Attaching the bracket to the crossmembers
LZH-70W Installation Instructions
Make a hole to install the cable
Mounting Screws