Electrolux ESL4300LO Notice D'utilisation page 8

8 www.electrolux.com
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when only the indicator of the
programme
When you activate the appliance, usually it
is in programme selection mode.
However, if this does not happen, you can
set the programme selection mode in the
following way:
Press and hold simultaneously
and
programme selection mode.
Water hardness
German de-
grees (°dH)
47 -50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
1) Factory setting.
2) Do not use salt at this level.
How to set the water softener
level
The appliance must be in programme
selection mode:
1. To enter the user mode, press and
hold simultaneously
is on.
until the appliance is in
French de-
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<4 <7
6.2 The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
mmol/l Clarke de-
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
until the indicators
2. Press
• The indicators
go off.
• The indicator
and
flash.
Water softener
grees level
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
5
18 - 22
13 - 17
5 - 12
< 5
1
and start to flash.
.
continues to
10
9
8
7
6
1)
4
3
2
2)
,
and