∙
Drill four 6 mm diameter holes in the wall, as shown in picture 5. A drill pattern is
provided to help you marking the correct position of the holes;
∙
Insert the four wall plugs supplied with the product;
∙
Fix the upper and the lower brackets as shown in picture 6;
∙
Hang the product to the upper bracket and then hook it up to the lower bracket
untill you ear a "click" as shown in picture 7.
Portable use
∙
If you want to use the fan heater as portable you have to extract the foot placed on
the back of the appliance as shown in picture 8. Just pull it until you ear a "click"
and check that the foot is firmly locked in its extracetd position.
Using the fan heater
∙
The heater is fitted with a switch and an ambient thermostat as shown in picture 9.
∙
The switch is used to control heater's functioning selecting the off condition, cold
air ventilation, warm air (1000W) or hot air (1800W).
∙
The heater is also equiped with an alarm light (picture 10) that switches on in case
of overheting/malfunctioning. It is not a functioning light and, consequentely, it
will not switch on during normal functioning.
∙
Do not put anything on the heater to avoid any overheating/malfunctioning both
in portable use (picture 11) or fixed installation (picture 4).
Using the thermostat
∙
In a room with a temperature exceeding 30°C, the thermostat does not turn on the
fan heater even if it is at maximum.
∙
Vice-versa, in a room with a very low temperature (below 5°C), it is normal that the
thermostat keeps the heater constantly on, even if it is at minimum.
∙
To optimise use of the thermostat, proceed as follows:
∙
turn the thermostat knob to maximum and wait until a comfortable temperature is
reached;
∙
then turn the thermostat knob anti-clockwise until you hear a "click" and the hea-
ter turns off;
∙
turn the thermostat knob clockwise just a little;
∙
in this position, the thermostat will maintain the selected ambient temperature.
Filter
∙
This product is fitted with a filter to protect the heating element from dust and
dirt.
∙
The filter is removable to be easily cleaned with water.
∙
To remove the filter just unlock the tab by pressing on it and pull towards you as
shown in picture 12.
∙
To keep the heater in perfect condition, clean the filter once every six months RE-
MEMBERING TO PUT IT BACK AGAIN AFTERWARDS.
12
Troubleshooting
∙
In the event of overheating, the safety device on the appliance automatically disa-
bled the heating elements and motor. As a result, the heater stops working . In this
case:
∙
Turn off the fan heater and allow it to cool down for about 15/20 minutes.
∙
Eliminate any other possible reasons for overheating (e.g.: obstructions in front of
the air inlet/outlet grilles, build-ups of dirt).
∙
Turn on the fan heater again and check it works correctly.
Maintenance
∙
This product does not require any special maintenance.
∙
Clean the product with a dry cloth once every 6 months.
∙
If the product requires repairing, contact an authorised technical service centre.
∙
When replacing the power cable, use a 2x0,75mm2 H05VV-F HAR type. This opera-
tion must be performed by qualified personnel and never by the end user in order
to avoid damaging the appliance and jeopardising personal safety.
Disposal:
Packaging disposal:
Do not throw away the package materials. Please put it in the recycling bin.
Gift box: Paper, should be put to the old paper collection point.
Plastic packaging material and foils should be collected in the
special collection containers.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe
recycling.
Service and Repair:
If the appliance must be repaired, plaese get in touch with your trader or with the
manufacturer:
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18, Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: elektro@steba.com Internet: http://www.steba.com
13