Installation - Pioneer DEH-P90DAB Manuel D'utilisation

Installation

Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunction.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver's way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.
• To prevent the ASL unit hanging from the
main unit from scratching the main unit or
your car console, it is wrapped in bubble pack-
aging. When installing, be sure to first remove
the bubble packaging to assure the unit func-
tions correctly.
• When connecting a DAB antenna to this unit, use
only a Pioneer product such as the AN-70DAB or
AN-75DAB (sold separately). If not, it may cause
malfunction.
• If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance.
(Fig. 4)
• The cords must not cover up the area shown in the
figure below. This is necessary to allow the
amplifiers to radiate freely. (Fig. 5)
Do not close this area.
60°
Fig. 4
Fig. 5
6