Troubleshooting - MAGIMIX 11630 CH Mode D'emploi

Problem
The lid is stiff
Flashing light
Your appliance will not
start
The ingredients are not
properly mixed/blended
Leaking base
Desserts programme
does not work
The motor smells
Stained plastic parts
The mixture tends to stick
to the sides
Solution
As the lid is designed to be watertight, it can be a little
hard to fit, especially if the appliance is new or has not
been used for a long time� Pour a little vegetable oil onto
some kitchen paper and rub the seal
Jug or attachment incorrectly positioned
Motor overload: switch your appliance off and wait for
30 minutes before switching it back on
Check the plug/socket
If the white indicator light is on, reposition the jug, then
select a speed or programme and press AUTO
Add some liquid
Always add the ingredients in the right order
Glass jug: use the spatula
Cut the ingredients into smaller pieces
Check that the blade assembly seal is correctly
positioned
Check that the support is screwed on properly to the
base of the jug
Glass jug: use the spatula
Frozen fruit: break into cubes measuring roughly 2cm
before putting in the blender, to avoid damaging your
appliance
Do not exceed the blender capacity and add a little
liquid
Use the spatula
There may be a faint smell when you use your appliance
for the first time or if the motor is overloaded� This poses
absolutely no risk, and the smell will go away after you
have used your appliance a few times� Allow the motor
to cool for 30 minutes before restarting it
Some ingredients, such as curry and carrots, may give
rise to some staining� Pour some vegetable oil onto
kitchen paper and rub the parts before adding the
ingredients
Add some liquid
Use the spatula, start at a low speed and gradually
increase it

TROUBLESHOOTING

33