Supported Devices - Stanley STHT1-77366 Mode D'emploi

User Manual
GB
4
Longest life and best performance can be
obtained if the battery pack is charged when
the air temperature is between 18° and 24 °C
(65 °F – 75 °F).
Never use any charger or cable that is damaged, as
it may present a risk of fi re, explosion, leakage, or
other hazard.
FCC Information
Smart Measure Pro
Model: STHT1-77366
Bluetooth Information
FCC ID: 2ACBG3000
IC ID: 11952A-3000
End of Life
DO NOT dispose of this product with household
waste.
PLEASE RECYCLE in line with local provisions for the
collection and disposal of electrical and electronic
waste.
Declaration of Conformity
This product conforms with IEC60825:2014.
Maintenance and Care
DO NOT allow to get wet. Damage to internal
circuits may result. Laser tool is not waterproof.
DO NOT leave laser tool in direct sunlight or expose
it to high temperatures. The housing and some
internal parts are polymeric materials and may
become deformed at high temperatures.
DO NOT store the laser tool in a cold environment.
Moisture may form on interior parts when warming
up. This moisture could fog up laser windows and /
or cause corrosion of internal circuit boards.
NOTE: When working in dusty locations, some
dirt may collect on the laser window. Remove any
moisture or dirt with a soft, dry cloth.
DO NOT use aggressive cleaning agents or solvents.
Charging Your Smart Measure Pro
Your Smart Measure Pro has an internal, non-
removable, rechargeable battery. Do not attempt
to remove the battery from the device as you may
damage the device. To charge the unit, connect the
USB charging cable into the micro USB charging port
on the unit and then plug it in to an appropriate
USB port. Longest life and best performance can
be obtained if the battery pack is charged when
the air temperature is between 18° and 24 °C
(65 °F – 75 °F). DO NOT charge the battery pack
in an air temperature below +4.5 °C (+40 °F), or
above +40.5 °C (+105 °F ). This is important and
will prevent serious damage to the battery pack.
NOTE: While the unit is charging, the LED indicator
will fl ash green. When charging is complete, the LED
indicator will be solid green. The Bluetooth
will fully recharge in 4 hours or less.

Supported Devices

Stanley Smart Measure Pro currently supports the
following:
Apple iOS
Google Android
* Must support Bluetooth Smart (v.4 – low energy)
For list of compatible devices, visit:
www.stanleysmartmeasurepro.com
* The clamp included with your Smart Measure Pro
will fi t on any device that is between 45mm and
80mm wide (inclusive of any case that may be on
the device).+
device
iOS 8.0 or later
v4.4 or later
®