Device Info - Velleman CAMIP5 Notice D'emploi

• When entering an administrator password, the user can open the For Operator layout.
• In this layout, it is possible to pan/tilt the camera using the control panel:
auto tilt (vertical movement)
auto pan (horizontal movement)
make alarm output [11.1] active.
Note: when the camera is in auto tilt/auto pan mode, motion detection and external alarm input are
disabled!
• Check the Flip checkbox in case the image is shown upside down.
• Check the Mirror checkbox to mirror the image.
• Set the resolution to 320*240 or 640*480.
• Set the mode to 50Hz or 60Hz.
Note: the camera is not suitable for outdoor use! The outdoor setting could be used in case the
camera is pointed towards a bright natural light source.
• Set the brightness and contrast of the image with the "+" and "-" buttons.
For Administrator layout
• The For Administrator layout is only available when logged in with an administrator account. It
is used for advanced configuration of the cameras.
Notes:
• Select the desired camera before opening the For Administrator layout.
• Depending on the ticked checkboxes, different data entry fields are shown. Hence the
display you see for a certain option might differ from the images used below.

Device info

• Device ID, firmware version and Web User Interface version are shown (see image above).
27.10.2010
CAMIP5
Press on the arrows around the blue button to move in that
direction.
Press and hold to move faster.
Press in the centre to start auto-scanning the whole area.
10
stop auto tilt
stop auto pan
deactivate alarm output
Rev.01
©Velleman nv