Build Worker BRMS1802-254LA Traduction Des Instructions D'origine page 47

speed
Blade Diameter
Cutting width 90 °
Cut angle
NEVER use water
for cutting.
Wear ear protection.
Wear eye protection.
Always wear a dust
mask.
Wear protective gloves
when handling the blade
replacement.
Do not use this blade for
cutting metal
This blade cuts wood
Do not use this blade for
cutting brick.
Do not use dull blades,
cracked, bent or damaged.
SAFETY RULES FOR LASER
LIGHTS
The laser light/laser radiation used in the DE
FENG laser system is Class 2 with maximum
1mW and 650nm wavelengths. These lasers do
not normally present an optical hazard,
although staring at the beam may cause flash
blindness.
WARNING. Do not stare directly at the laser
beam. A hazard may exist if you deliberately
stare into the beam, please observe all safety
rules as follows;
• The laser shall be used and maintained in
accordance with the manufacturer's
instructions.
• Never aim the beam at any person or an
object other than the workpiece.
• The laser beam shall not be deliberately
aimed at personnel and shall be prevented from
being directed towards the eye of a person.
• Always ensure the laser beam is aimed at a
sturdy workpiece without reflective surfaces. I.e.
wood or rough coated surfaces are acceptable.
Bright shiny reflective sheet steel or the like is
not suitable for laser use as the reflective
surface could direct the beam back at the
operator.
• Do not change the laser light assembly with a
different type. Repairs must be carried out by
the laser manufacturer or an authorized agent.
CAUTION. Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure. Please refer to the relevant
47