Build Worker BRMS1802-254LA Traduction Des Instructions D'origine page 46

- Fixing the machine to a workbench.
The machine must be screwed to a workbench.
Mark the position of the mounting holes (A)
■
on the workbench.
Drill holes at each of the marked positions,
■
adjusting the diameter and depth of the holes to
the screws used.
Place the machine on the workbench and
■
insert the screws into the mounting holes.
Firmly tighten the screws.
■
- Information to set the minimum size of
the pieces to be cut
Minimal workpiece sizes (= all workpieces that
can be clamped left or right from the saw blade
with the provided quick-action clamp "E"
160 x 30 mm (length x width)
- Information on the maximum cross
section of a workpiece in a cross
Bevel
0°
310 mm
0°
x 73 mm
210 mm
45°
x 73 mm
- The outer diameter ranges, the bore
diameter and the thickness of the
blades can be used
Blade Diameter 254 mm
Bore diameter 30 mm
Blade thickness 2.8 mm
Miter angle
45°
310mm
x 40 mm
210 mm
x 40 mm
- The maximum depth of cut
Cutting capacity, max. (0° /0° ): 310x73 mm
WARNING: Packaging
materials are not toys!
Children must not play with
plastic bags! Danger of
In this manual and/or on the machine the
following symbols are used:
Read manual before use.
Wear ear protection.
Wear eye protection.
Always wear a dust
To avoid injuries caused by
machine head downwards
after cutting until the blade
is completely stopped.
Keep hands away from
the cutting area while the
machine is running.
Danger of injury when
coming in contact with the
For your safety, remove the
chips and other small
pieces on the table before
essential applicable
safety standards of
European directives
suffocation!
Warning / Danger!
mask.
projected keep the
saw blade.
starting work.
In accordance with
Double insulated
46