Cut To Edge; Working Time - Worx LANDROID Mode D'emploi

E1

5.3 Cut to edge

Off-centered Blade Turning Disc (13) design provides a clean cut
with narrowest distance to the boundary or wall. It helps minimize
the amount and frequency of manual trimming along the boundary.
®
Additionally, the Landroid is designed with a protective cover
underneath that prevents objects from touching the turning blades
and/or injury. (See Fig. F)

5.4 Working time

®
Landroid 's default daily working schedule includes 4 hours of working
time (mowing and charging included), and 20 hours on standby on the
charging base. See chart below. The working schedule can be changed
using the mobile app (only available for some models). Please check
Technical Data & Declaration of Conformity for information specific
to each model. To download the app, please refer to section APP .
The working schedule can be re-set by removing and re-installing the
battery. Please refer to Replacing the Battery.
Working Standby
4h 20h
Day 1
Default working schedule
9:00~13:00 everyday (including charging time)
Tall grass working schedule
For the first mowing when the grass grows very tall after winter or a long
holiday, you can change it to tall grass mowing mode by keep pressing
button for 5 seconds until a beep sound is heard. Press
®
start mowing. Landroid will resume to previous start time and the default
working duration in the following days.
Change default start time
The default start time of 9:00 can be changed to anytime by keep pressing
both and buttons at the same time for 3 seconds until a beep
sound is heard.
For example, keep pressing both
®
Landroid will be mowing from 14:05 to 18:05.
NOTE: If your Landroid ®
is shut off, it will resume to default working duration and the start time will resume to previous
setting when the machine is re-started.
NOTE: When you replace the battery, the working duration will resume to default working duration and the start time is set to
the moment when the battery re-connected.
Owner's Manual of Lawn Mowing Robot EN
Working Standby Working
4h 20h
Day 2
Everyday
and buttons at 14:05, and your
E2
"Cut to Edge" Tech
F
Standby
4h 20h
Day 3
13:00
4hrs
then to
Working Standby
4h 20h
Day 7
Day 1
10hrs
Day 2 4hrs
Day 3
4hrs
Everyday
4hrs
11