Software Update; Maintenance; Keep It Sharp - Worx LANDROID Mode D'emploi

8.

Software update

The software can be updated when new versions become
available. The latest software can be downloaded from our website
www.worxlandroid.com. There are two methods to update
software.
Method 1: Update via USB. See below for download and
installation instructions:
(1) Locate the latest software version at: www.worxlandroid.com.
Save the file to an empty FAT32 formatted USB (flash drive).
Delete any other files on the drive and check the format. If the
drive is not formatted in FAT32, please reformat the drive.
NOTE: the software update is downloaded as a zipped file. You
will need to unzip or extract it before proceeding.
(2) Place Landroid
Switch to the "O" position to turn off your Landroid
(3) Lift the rear of the Landroid
(4) Open the protective rubber cover under the Landroid
(5) Insert the USB drive (flash drive) in the port. (See Fig. K)
(6) Place the Landroid
(7) Turn the Main Switch to the "I" position to turn on the Landroid
(8) The battery indication light will start to pulse. When the error indication light flashes blue, the file has been copied.
(9) Without lifting the Landroid
(10) The update will begin automatically and may take several minutes. The final alert sequence will include a beep, and both
the battery indication light and error indication light will flash. When the error indication light turns off and only the green
battery indication light remains lit, the update is complete.
NOTE: If the Landroid
refer to the manual for more information.
(11) Be sure to tightly and completely close the rubber protective USB port cover.
Method 2: Update via your smartphone. (For specific models only. Please check Technical Data & Declaration of Conformity for
14
information specific to each model.)
®
If your Landroid is connected to your smartphone via the Landroid
also notify you when new software version is available.
The manual included with your Landroid
functions in the new version may not exist in the manual. If you found some settings not in the manual, please visit www.
worxlandroid.com to download the latest manual.
9.

Maintenance

®
Your Landroid works hard and needs to be cleaned and checked from time to time. Some parts will require replacement
as they become worn. Never use your Landroid
Switch off the machine before carrying out any service or maintenance.
Here's how to take care of your Landroid

9.1 Keep it sharp

WARNING: Before cleaning, adjusting, or
replacing the Blades, turn your Landroid
put on protective gloves.
WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure
blade retention and balance the blade turning disc.
Failure to use new screws could cause serious injury.
®
The Landroid does not cut grass like other mowers. Its Cutting
Blades (12) are razor sharp on 2 edges and rotate in both directions
for maximum cutting capacity (See Fig. L). Each blade of your
®
Landroid has 2 cutting edges. The Blade Turning Disc will make
forward and reverse rotation at random to use both cutting edges and minimize the frequency of replacing the blades.
Each cutting blade will last up to 2 months when it is programmed to mow everyday. Always check to see if the Blades
Owner's Manual of Lawn Mowing Robot EN
®
on a secure and level surface. Turn the Main
®
to access the underside.
®
on the ground again.
®
, remove the USB drive (flash drive).
®
is not inside the boundary wire, the error indication light will flash RED after the update. Please
®
is based on the default software at the time of production.Some new features/
®
.
K
®
.
®
to access the USB port.
®
.
®
App, you can check the software version. The App will
®
with defective main switch.
®
OFF and
L
1
2