Upper Axle; Holder; Mixer Blades; Middle Axle - Unold 48860 Notice D'utilisation

Mixer
10. Carefully pull the motor out of the
cooling container.
11. Clean the mixer with warm water
and a mild washing-up liquid.
12. You can take the mixer apart for
easy and thorough cleaning:
13. To do this, remove the lower axle
on the underside of the mixer by
lifting up the locking ring and
detaching the lower axle from the
holder. Pull out the lower axle.
14. This is the only way to detach the
middle axle. Turn the blades of
the middle axle counter-clockwise
until it detaches. The mixer bla-
des can now be taken off.
15. Thoroughly clean all parts with
warm water and a mild washing-
up liquid, then dry all parts tho-
roughly.
16. Put the component parts back
together again in the reverse
sequence:
17. Slide the middle axle into the
mixer to the stop.
18. Firmly screw in the mixer blade
(turn counter-clockwise).
4
1
2
3

1 Upper axle

2 Middle axle

3 Lower axle
4 Locking ring

5 Holder

6 Mixer blades

30
5
6
19. Slide the lower axle through the
middle axle, guide the upper end
of the axle into the holder, and fix
it in place with the locking ring.
Cooling container with ring
20. Caution: If condensation forms
between the cooling container
and the upper part of the housing,
removal of the cooling container is
more difficult. Do not use force to
pull the cooling container out of
the upper part of the housing; in
this case wait until all parts have
warmed up to room temperature.
21. To prevent injury or freezing, allow
the cooling container to warm up
to room temperature, before you
clean it.
22. Turn the ring clockwise and pull it
downward and off of the cooling
container.
23. Wipe off the inside of the cooling
container with a damp cloth and
then dry it thoroughly.
24. Likewise, wipe off the locking ring
with a damp cloth and then dry it
carefully.
Discharge valve
25. Take the upper part of the housing
off of the lower part of the housing.
26. Carefully turn the discharge valve
clockwise and take it off.
27. Thoroughly clean all parts with
warm water and a mild washing-
up liquid, then dry all parts tho-
roughly.
28. To re-insert the discharge valve,
place in on the underside of the
upper part of the housing and
turn it slightly counter-clockwise
until it locks in place.