Bartscher 401.619 Mode D'emploi page 5

•
Drill two holes in the wall.
•
Leave a space of 280 mm between the holes, as
shown in figure 2.
•
Insert the dowels and screws included with the
unit into the drilled holes and hang the basin on
them.
•
Connect the basin to the water supply using the
included assembly kit. The basin may be
connected to either hot or cold water, or both.
•
Connect the basin to a drain pipe.
•
The basin is activated by pressing the plate at
the front with one's knee (fig. 3).
•
Water will flow from the tap for approx. 15
seconds. After this time the flow will
automatically shut off.
•
The proportion of hot and cold water is controlled using
the regulating screw (fig. 4).
Washing
•
Wash the basin regularly using a soft cloth and non-
abrasive cleaning substance.
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten
Germany
- 4 -
phone: +49 (0) 5258 971-0
fax: +49 (0) 5258 971-120
Fig. 2
Fig. 3
Fig. 4