Zwilling FRESH & SAVE Manuel D'utilisation page 47

Troubleshooting
Problem
The above prob-
lems cannot be
solved.
The pump stops
during the vacuum
sealing process and
does not turn back
on.
www.zwilling.com
Possible cause
The vacuum pump could
be broken.
The pump sucked in
liquids during the vacuum
sealing process.
Remedy
Contact customer service. Do not try to
repair the pump yourself.
Do not turn the pump upside down. Shake
the pump slightly to remove any liquid.
Make sure the pump and the charging sta-
tion are completely dry. Plug the pump into
the charging station for one second to reset,
then remove it and push the On/Off button.
Additional liquids may drip out. Repeat this
process if the pump stops again.
GB
47