Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to clean
●
Do not use the following:
●
Do not use benzine, thinner, alcohol, bleach, polishing powder, metal brush or nylon brush, otherwise
the surface will be damaged.
●
Do not clean the appliance with pointed object such as a toothpick or pin.
Food pusher/lid
Wash with diluted dish soap
(neutral) and a soft sponge. Then
rinse thoroughly with water and dry
well.
* NOT dishwasher safe
Frozen attachment
Wash with diluted dish soap
(neutral) and a soft sponge. Then
rinse thoroughly with water and dry
well.
* Dishwasher safe
Rotating brush
(P. EN17)
Juicing bowl
(P. EN17)
Motor housing
Wipe with a well-wrung cloth.
* NOT dishwasher safe
Dishwasher safe parts
●
Before putting the parts into a dishwasher, remove residue on the parts.
●
Heat may cause cracking of parts. Always place the parts away from any heater or set a low
temperature of heater.
EN16
Clean the appliance after every use.
CAUTION: Unplug before cleaning.
About discoloration of parts
Some discolouration of parts may
occur upon using ingredients like
carrot or leaf vegetable etc.
Cleaning all parts immediately after
each use will help to reduce stains.
Squeezing screw/Filter
Wash with diluted dish soap
(neutral) and a soft sponge. Then
rinse thoroughly with water and dry
well.
brush to clean the
bottom surface of
squeezing screw.
use the cleaning brush to
clean.
* Dishwasher safe
Accessories
Wash with diluted dish soap
(neutral) and a soft sponge. Then
rinse thoroughly with water and dry
well.
* Dishwasher safe
Rotating brush/Juicing bowl
Wash with diluted dish soap (neutral) and a soft sponge. Then rinse thoroughly with water and dry well.
After drying all the parts, assemble them correctly.
●
Use the tip of cleaning brush handle to clean the spouts of the juicing bowl.
(The inner surface may be scratched if you use the cleaning brush to clean it.)
To disassembling
Push the rubber brush to the direction
Insert the upper/lower grooves of the rubber brush into
indicated by the arrow mark and take the
the gap and then slide it all the way up/down both ends.
part out from the gap.
●
Note
Do not pull the rubber brush hard.
Rubber brush
Gap
①
●
●
②
④
●
●
③
■ Gasket of the inner side of the
■
To disassemble
To disassemble
Pull the gasket
up.
To assemble
Push the
gasket into
opening as
figure bellow.
Pull the rubber plug out in the
direction of the arrow.
Push
●
Cannot be removed from
the juicing bowl.
Sectional view
About the rubber brushes, gasket and rubber plug
■
●
After washing, drain off water well and then assemble them.
Do not leave them unassembled.
(Otherwise there is a risk of loss, choking on and swallowing of little parts by children, product failure,
or leakage of juice.)
●
To avoid formation of rust, dry the parts after washing.
Storage
●
To avoid failure, do not place the motor housing up-side down.
●
To move the juicer, separate the juicing bowl from the motor housing and
hold them with both hands. (P. EN7).
●
Store the appliance in a place that is beyond the reach of young children.
* NOT dishwasher safe
To assemble
To avoid damaging the juicer, make sure the upper
and lower grooves are in the correct position.
Insert the groove to
Gap
the projected part.
Upper
(Long)
Lower
(Short)
Top view
To assemble
Push the rubber
plug into the
opening in the
direction of the
arrow until there
is no gap.
EN17
Publicité
Table des Matières
