Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before Use
Disassembling/Assembling attachments
●
The following steps show how to disassemble/assemble attachments, using the juice attachment as
an example.
The frozen attachment can be disassembled/assembled in the same method.
To disassemble
1
Remove the
from the motor
2
Remove the juice
●
The squeezing screw comes out with it.
Squeezing
screw
(
Frozen
attachment
3
Filter
(
Frozen
attachment
Rotating
brush
EN10
1
●
The gasket is located in the juicing bowl.
Top view
●
The rubber plug is located on the outer
bottom.
Push it in until
)
no gap.
Outer bottom view
●
Rubber brushes are located on side of the
rotating brush.
See page EN17 for how to install the gasket,
rubber plug and rubber brushes.
)
●
The juicer may not work properly if
they are not assembled correctly.
To assemble
2
U
Align the "
" mark on the motor housing and
V
the "
" on the juicing bowl.
3
U
Align the "
" mark on the motor housing and
T
the "
" mark on the juice attachment.
Top view
4
1 Insert the squeezing screw into the center.
2 Rotate the squeezing screw and push it into
the hole until it stops.
●
The lid cannot be closed if the squeezing
screw is not pushed down sufficiently.
●
Be careful not to get your finger clamped in
the gap between the squeezing screw and
the filter.
CAUTION: Be sure the appliance is unplugged.
(
Frozen
)
attachment
①
●
②
●
EN11
Publicité
Table des Matières
