TallyGenicom 6600 Série Guide De Référence Rapide page 9

Tab (2)
Tab Slot (2)
Figure 2. Installing the Ribbon Cartridge
4. Remove the ribbon slack on the ribbon cartridge by turning the
ribbon tension knob clockwise.
CAUTION
Do not turn the ribbon tension knob counterclockwise. This
could damage the ribbon cartridge.
5. Hold the cartridge at an angle, so that the rear side nearest you
is lower than the side with the ribbon. Find the two tabs on the
outside of the cartridge and place them into the corresponding
slots on the air shroud assembly (see Figure 2).
Loading Ribbon Cartridge
Ribbon
Ribbon
Cartridge
Ribbon Tension
Knob
Air Shroud
Assembly
1
9