gigamedia GGM AXA1EMK2K Manuel Utilisateur page 8

GGM AXA1 - Series access control
To delete a card user by card number.
This option can be used when the user want to make the change but the card has lost
2 Card number
Note users can be deleted continuously without exiting programming mode
To add a card and PIN user in card and PIN mode
( )
3 1 #
To Add a card and Pin user
(The PIN is any four digits between 0000 & 9999 with the exception of 1234 which is reserved.)
Add the card as for a card user
Press * to exit from the programming mode
Then allocate the card a PIN as follows:
* Read Card
To change a PIN in card and PIN mode (Method 1)
Note that this is done outside programming mode so the user can undertake this themselves
* Read Card Old PIN #
To change a PIN in card and PIN mode (Method 2)
* ID Number #
Note that this is done outside programming mode so the user can undertake this themselves
To delete a Card and PIN user just delete the card
2 User ID #
To add a card user in card mode
( 3 0 # )
To Add and Delete a card user
The operating is the same as adding and deleting a card user in
To delete All users
2 0000 #
Note that this is a dangerous option so use with care
To unlock the door
For a PIN user
Enter the PIN
For a card User
Read card
For a card and PIN user
Read card then enter
#
1234# PIN # PIN #
New PIN # New PIN #
Old PIN # New PIN # New PIN #
then press #
PIN #
9
User Manual
3 0 #
EN