Packing List - gigamedia GGM AXA1EMK2K Manuel Utilisateur

GGM AXA1 - Series access control
1.

Packing List

• 1 Keypad
• 1 User manual
• 1 Screw driver
• 2 Rubber plug
• 2 Self tapping screws
• 1 Star screws
Please ensure that all the above contents are correct.
If any are missing please notify the supplier of the unit.
2. Quick Reference Programming Guide
To enter the programming mode
* Master code
999999 is the default factory master code
To exit from the programming mode
*
Note that to undertake the following programming the master user must be logged in
To change the master code
0 New code #
The master code can be 6 to 8 digits
To add a PIN user.
1 User ID number
The ID number is any number between 1 & 2000.
The PIN is any four digits between 0000 & 9999
with the exception of 1234 which is reserved.
Users can be added continuously without exiting programming mode
To add a card user
1 Read Card #
Cards can be added continuously without exiting programming mode
To delete a PIN or a card user.
2 User ID number
2 Read Card #
Users can be deleted continuously without exiting programming mode
To unlock the door for a PIN user
Enter the PIN then press
To unlock the door for a card user
Present the card
Ø 20mm×60mm,Special for keypad
Ø 6mm×30 mm, used for fi xing
Ø 4mm×28 mm, used for fi xing
Ø 3mm×6mm, used for fi xing
#
New code #
# PIN #
# for a PIN user or
for a card user
#
Standalone Keypad Access Control
3
User Manual
EN