Setting The Clock; Switching The Warning Tone; Switching The Auxiliary Setting; List Tts (Text To Speech) Playback - Pioneer SuperTuner IIID DEH-P7100BT Mode D'emploi

Initial Settings

Setting the clock

Use these instructions to set the clock.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select Clock in
the initial setting menu.
3 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
# You can match the clock to a time signal by
pressing MULTI-CONTROL.
! If 00 to 29, the minutes are rounded down.
(e.g., 10:18 becomes 10:00.)
! If 30 to 59, the minutes are rounded up.
(e.g., 10:36 becomes 11:00.)
4 Push MULTI-CONTROL up or down to
put a clock right.

Switching the warning tone

If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select
Warning tone in the initial setting menu.
3 Press MULTI-CONTROL to turn warning
tone on.
# To turn warning tone off, press
MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 53.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select AUX1/
AUX2.
3 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
List TTS (Text to speech)
Playback
TTS playback can be performed for an item se-
lected with the cursor in a list. If this is set to
on, any item the cursor is on for 2 seconds or
longer is read out.
! This function is available for the name in
the following lists:
— Phone book (phone book)
— Missed calls (missed call history)
— Dialed calls (dialed call history)
— Received calls (received call history)
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select
List guidance.
3 Press MULTI-CONTROL to turn
List guidance on.
# To turn this function off, press
MULTI-CONTROL again.
Section
11
49
En