Audio Adjustments; Introduction Of Audio Adjustments; Using Balance Adjustment; Using The Equalizer - Pioneer SuperTuner IIID DEH-P7100BT Mode D'emploi

Audio Adjustments

Introduction of audio
adjustments
1 1 1
1 Audio display
Shows the audio adjustment status.
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option. Press to se-
lect.
The audio menu is displayed.
3 Turn MULTI-CONTROL to select the
audio function.
Turn MULTI-CONTROL to switch between the
audio functions in the following order.
Fader (balance adjustment)—Powerful (gra-
phic equalizer adjustment)—50Hz (7-band
graphic equalizer adjustment)—Loudness
(loudness)—SubWoofer1 (subwoofer on/off
setting)—SubWoofer2 (subwoofer setting)—
Bass (bass boost)—HPF (high pass filter)—
SLA (source level adjustment)—Guide VOL
(voice guidance volume adjustment)
# You can select the SubWoofer2 only when
subwoofer output is turned on in SubWoofer1.
# When selecting FM as the source, you cannot
switch to SLA.
# If TEL is selected as a source, only Fader (bal-
ance adjustment) and Guide VOL (guidance vo-
lume) can be operated.
# To return to the display of each source, press
BAND/ESC/CANCEL.
# If you do not operate functions except for
50Hz within about 30 seconds, the display is
automatically returned to the ordinary display.

Using balance adjustment

You can change the fader/balance setting so
that it can provide the ideal listening environ-
ment in all occupied seats.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
this page.
2 Use MULTI-CONTROL to select Fader in
the audio function menu.
# If the balance setting has been previously ad-
justed, Balance will be displayed.
3 Push MULTI-CONTROL up or down to
adjust front/rear speaker balance.
Each time MULTI-CONTROL is pushed up or
down, the front/rear speaker balance moves
towards the front or rear.
Front 15 to Rear 15 is displayed as the front/
rear speaker balance moves from front to rear.
# F/R 0 is the proper setting when only two
speakers are used.
# When the rear output setting is Rear SP :S/W,
you cannot adjust front/rear speaker balance.
Refer to Setting the rear output and subwoofer out-
put on page 50.
4 Push MULTI-CONTROL left or right to
adjust left/right speaker balance.
Each time MULTI-CONTROL is pushed left or
right, the left/right speaker balance moves to-
wards the left or right.
Left 15 to Rear 15 is displayed as the left/right
speaker balance moves from left to right.

Using the equalizer

The equalizer lets you adjust the equalization
to match the car's interior acoustic character-
istics as desired.
Section
10
43
En