Using The Controls; Changing Programs - Hamilton Beach Commercial HBH750 Série Manuel D'utilisation

Using the Controls

1 2 3 4 5 P
These preset program buttons each have a blending cycle designed for commonly made drinks (see
separate drop-in). Each button can be changed to a different preprogrammed cycle using the directions
below.

Changing Programs

PROGRAM UNIT Hold
SELECT OR SCROLL
PROGRAM 1–8 There are 8 preset programs. Scroll up
SCROLL OR HOLD 1–5
assign a program or continue to scroll up
HIGH SPEED
Y-SELECT OR SCROLL
Press and scroll up
SELECT
NOTE: Saving a new cycle to a location will overwrite any existing cycle in that location.
P
JUMP
Hold button to run blender at high speed. Release to stop blender.
Information and Settings
PROGRAM UNIT Hold
SELECT OR SCROLL
INFORMATION Press
SELECT OR SCROLL
For all options below, press
during any option to exit program menu.
CYCLES INTO WARRANTY
CUSTOM CYCLE COUNTER
CLEAR CYCLE COUNTER
CUSTOMER SERVICE
DISPLAY BACKLIGHT
QUIET SHIELD SENSOR
RUN COOL DOWN CYCLE
FACTORY DEFAULTS
SOFTWARE VERSION
EEPROM VERSION
6
to program unit. Press
SELECT
LOW SPEED JUMP SPEED
Y-SELECT OR SCROLL
Y-SELECT OR SCROLL
to select cycle time. Hold button 1–5 to assign a program.
to enter the menu and scroll up
SELECT
to enter INFORMATION menu and scroll up
SELECT
to view information or scroll for next option. Press
SELECT
Display shows CYCLES INTO WARRANTY.
Display shows CUSTOM CYCLE COUNTER. This cycle counter can be reset by
the operator.
Display shows CLEAR CYCLE COUNTER. This option will only clear custom
cycle counter, not cycles into warranty.
Display shows CUSTOMER SERVICE.
Display shows DISPLAY BACKLIGHT. Scroll to enable or disable option for
constant display of backlight.
Display shows QUIET SHIELD SENSOR. This can only be disabled for 120V.
Display shows RUN COOL DOWN CYCLE. If the blender motor overheats, this
message will be displayed to prompt you to run a cool-down cycle. Remove
the container from the blender and press
must be closed.)
Display shows FACTORY DEFAULTS. This option will restore all programs to
factory defaults.
Display shows SOFTWARE VERSION.
Display shows EEPROM VERSION.
to continue.
SELECT
to view the program. Hold button 1–5 to
for the following additional programs.
to INFORMATION option.
. (For 230V, the Quiet Shield™
SELECT
to view below options.
a second time
SELECT