Installation Location; Installation Procedures - Clarion DVC920 Mode D'emploi

7. INSTALLATION

Installation Location

1. The unit can be placed in your glove compartment, or fastened to the center console, etc.
NOTE:
Do not install the control unit in locations that are exposed to high temperatures (e.g., on
dashboard), since deformation or damage may result.

Installation Procedures

1. Apply the small Velcro tape to the control unit.
• Be sure to remove any dust or soiling from the surface of the control unit before applying the tape.
2. Apply the medium Velcro tape to the center console or other location of the car you wish to install
the control unit. Then press the control unit to the Velcro tape.
• Be sure to remove any dust or soiling from the car surface before applying the tape.
3. Use the provided cord holder to secure the cord in place.
Velcro tape (small)
16
DVC920
280-7804-00_09-18(En)
Control unit
16
Velcro tape (medium)
SOURC E
A-MOD
E
ADJUS T
D S F
POWE R
Cord holder
2/22/02, 2:07 PM 280-7804-00