Wiring Techniques; How To Wire This Unit - Clarion DVC920 Mode D'emploi

6. WIRING TECHNIQUES

How to Wire This Unit

Perform the settings and
connections in the order
indicated by the drawing
below.
* Steps 4-6 may differ, de-
pending on the component
connected. For detailed in-
structions, consult the sec-
tion "SYSTEM EXPAN-
SION" on P 17-18.
5
Connect to center unit.
1
Set the [STAND-ALONE / SLAVE]
switch to the [STAND-ALONE] position.
SLAVE
Control Unit
SOURCE
2
Control Unit connection cord
(5m) (furnished with main unit)
Remote-On Cord.
Connect to the power
amplifier's remote-on cord.
Accessory (ACC) power cord.
Connect to a power terminal
that can be turned ON/OFF by
the ignition key.
Main power cord.
Connect to a power terminal that
provides continuous current (3A
minimum) regardless of status of
ignition key.
Ground cord.
Use a screw to fasten to a
metal part of the car frame.
14
DVC920
280-7804-00_09-18(En)
Throughout the process of wiring this unit,
disconnect the negative (–) terminal of your
automobile's battery, and leave it discon-
nected until completely finished. Handling
wires while the terminal is connected could
result in dangerous electrical shock or injury
if an accidental short circuit should occur.
4
RCA pin cable (purchase separately).
Connect to external amplifier.
CeNET cable.
STAND
ALONE
7
[RESET] switch
A-MODE ADJUST D S F POWER
Blue/white
Red
Accessory
terminal
Fuse (3A)
Yellow
3A
Accessory
terminal
Black
14
CAUTION
Black
Black
RCA pin cable
4
(sold separately).
Connect to center unit's
RCA audio output.
Optical Digital cable
6
(sold separately).
Connect to DVD/CD changer.
3
Power cable (5m)
(furnished with main unit)
2/22/02, 2:07 PM 280-7804-00