Operation; Applications - Ryobi WS750L Manuel D'utilisation

INSTALLING TILE CUTTING WHEEL
See Figures 16 - 17, page 23.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel capacity
of the saw. Never use a wheel that is too thick to allow
wheel washer to engage with the flats on the spindle.
Larger wheels will come in contact with the wheel guard,
while thicker wheels will prevent the wheel bolt from
securing the wheel on the spindle. Either of these situ-
ations could result in a serious accident and can cause
serious personal injury.
 Unplug the saw.
 Loosen the wheel guard lock.
 Open the wheel guard to expose the arbor nut.
 Fit the wheel wrench on the arbor nut then the hex key
in the spindle.
 Holding the hex key in place to prevent the wheel from
moving, turn the arbor nut counterclockwise. Remove
the hex key, wheel wrench, arbor nut and outer washer.
Do not remove the inner washer.
 Wipe a drop of oil onto inner washer where it contacts
the wheel.
WARNING:
If inner washer has been removed, replace it before
placing wheel on spindle. Failure to do so could cause
an accident since the wheel will not tighten properly.
Never use wheels that have openings, grooves, or teeth
on this tool.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is suf-
ficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes result-
ing in possible serious injury.
ASSEMBLy
 Place the cutting wheel onto the spindle.
 Replace outer cutting wheel washer. The double "D" flats
on the cutting wheel washers align with the flats on the
spindle.
 Using hex key and wheel wrench, tighten arbor nut
securely.
 Retighten the wheel guard lock securely.
INSTALLING THE RIP GUIDE
See Figure 18, page 23.
 Place the rip guide in the unlocked position (lever up).
 Fit the rip guide onto the permanent fence on the Easy
Glide Table
 Lock the rip guide in place by pushing the lever down.
CONNECTING THE DRAINAGE HOSE
See Figure 19, page 23.
Always place the drainage hose into a small barrel or bucket
so debris can drain from water tray.
 Unscrew the cap from the drainage output.
 Attach a drainage hose to the drainage output and place
other end of the hose into a bucket or barrel.
 Do not overflow the bucket or spill water on the ground
near the machine.
 Discard waste water in accordance with local regula-
tions.

OPERATION

WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.

APPLICATIONS

You may use this tool for the purposes listed below:
 Straight line cutting operations such as cross cutting,
mitering, ripping, and beveling
NOTE: This saw is designed to cut man-made tile, pavers,
natural stone products, and stone tile products only.
12 — English
.
™