Bartscher Compact Ice K 100073 Mode D'emploi page 26

•
If the ice cubes stick to each other, separate them gently with the help of the ice
spoon.
•
Keep checking the water level throughout the process. If the water pump cannot
inject water, the ice cube maker stops automatically, the sound signal is sent out
and the indicator
the device off.
•
Pour fresh drinking water into the container to just below the mark.
•
Press the „Start" button
•
Once the ice cube basket is full, the ice cube maker stops automatically.
•
The sound signal is sent out and the red indicator
lights up. Empty the ice cube basket.
•
Press the „Stop" button
cube making process.
CAUTION!
If the compressor has stopped for whatever the reason, e.g. no water, too many ice
cubes in the ice cube basket etc., wait for ca. three minutes for the cooling agent to
settle in the compressor before restarting the device.
•
If you are not going to use the device anymore, switch it off. Press the „Stop"
.
button
NOTE!
For reasons of hygiene, if you are not using the device for longer than 24 hours,
drain the water from the water container.
•
To remove water from the water tank,
place a container under the drainage pipe
at the bottom of the nit. Remove the ice
cube tray.
•
Open the drainage pipe by removing the
stopper at the bottom of the water tank
(see photo at right).
•
After the water tank is empty, replace the
stopper.
•
If after a longer stoppage you are going to use the device once again, pour fresh
water into the container, carry out 2-3 ice cube making cycles and remove the
produced ice cubes.
„Add water" lights up. Press the „Stop" button
to contine the ice cube making process.
and later on the „Start" button
„The ice cube basket is full"
to continue the ice
Drainage pipe
Stopper
to switch
- 25 -