Hoshizaki HRE-70B Notice D'utilisation page 5

ENGLISH
To hold the Front Panel open:
Hook the Front Panel securely on both sides of the
top as shown. It may be unhooked when pulled up
in the direction of arrow .
To unhook the Front Panel, lift up both sides of the
front (arrow ) and push in the direction of arrow 2.
Front Panel
Securely
Fig. 6
To remove the Front Panel:
Release both sides of the bottom from the Holders,
and lift it off vertically.
Holder
Fig. 7
[c] CABINET TEMPERATURE SETTING
The cabinet temperature is factory-adjusted to 3°
C for the refrigerator and -8°C for the freezer. If
necessary, readjust the temperature as follows:
) Open the Front Panel.
2) Press the Set Point Button to display the current
set point temperature.
3) Keep pressing the Set Point Button, and
push the Temperature Control Button until
the Temperature Display Window shows the
desired temperature. The cabinet temperature
is adjustable between -0°C and 6°C for the
refrigerator and between -7°C and -25°C for the
freezer.
4) The displayed cabinet temperature is adjusted
to be almost equal to the temperature at the
center of the cabinet without foods. But it can be
different from the actual temperature depending
on arrangement of stored foods, frequency of
door opening or measuring points.
Front Panel
Set Point Button
Temperature
Display Window
[d] FRAME HEATER
Front Panel
The Front Frame is provided with a built-in heater
to prevent condensation. It is factory-adjusted to
"low". If condensation forms on the Front Frame,
the Frame Heater can be adjusted to "high".
Press the Frame Heater Button on the Operation
Panel for more than 3 seconds. The lamp will
illuminate and the Frame Heater will be adjusted to
"high".
To change the setting to "low", press the Frame
Heater Button for more than 3 seconds. The lamp
will go out and the Frame Heater will be set to "low".
[e] DEFROST
The refrigerator/freezer automatically defrosts the
Evaporator every 6 hours. For the refrigerator, the
Temperature Display Window shows the cabinet
temperature and "dF" alternately during defrost
cycle. For the freezer, the Temperature Display
Window shows "dF" during defrost cycle.
To start a manual defrost cycle, press the Manual
Defrost Button for more than 5 seconds. The next
defrost cycle will begin in 6 hours.
[f] LOCK
The Door Lock is provided on the top or side of
4
Frame Heater
Button
Reset Button
Fig. 8
Manual Defrost
Button
Temperature
Control Button