Ibiza sound MIX500BT Manuel D'utilisation page 3

CHANNEL CONTROL SECTION
1. CH 1 Gain Control: Use this knob to adjust the gain of LINE 1 input
signal
2. CH 1 Treble Control: Use this knob to adjust the treble of LINE 1 input
signal
3. CH 1 Bass control: Use this knob to adjust the bass of the LINE 1 input
signal
4. MIC VOL: Use this knob to adjust the volume of the microphone volume
5. USB Input: Connect the USB here
6. USB/Bluetooth & Line Selector: Press the selector to switch the input
between USB/Bluetooth and Line input.
7. CH 2 Gain Control: Use this knob to adjust the gain of LINE 2 input
signal
8. CH 2 Treble: Use this knob to adjust the treble of LINE 2 input signal
9. CH 2 Bass Control: Use this knob to adjust the bass of the LINE 2 input
signal
10. Headphone Vol: Use this knob to adjust the volume of headphone output
11. Master VOL: Use this knob to adjust the master volume
12. Line signal selector: Set the selector to the left side to mute the CH2 input signal and set the selector to
the right side to mute the CH 1 input signal. If the selector is in the middle position, both CH 1 input signal
& CH 2 input signal will be mixed and sent to OUTPUT Jacks.
REAR PANEL CONTROLS:
1. 12V Power supply: Connect the adapter here
2. Master output: Connect this output to the RCA input of an ampli-
fier or active speaker
3. REC output: Connect this output to the RCA input of a tape
recorder, amplifier or active speaker.
4. Line 2 input: Connect the Line 2 Signal here. This is CH 2 signal.
5. Line 1 input: Connect the Line 1 signal here. This is CH 1 signal.
CONTROLS
1. MIC input: Connect the microphone here
2. USB/Bluetooth Selector: Press this button to switch the input
between USB & Bluetooth.
3. Play/Pause: Press this button to play the signal from USB & Blue-
tooth. Press again to pause.
4. PREVIOUS: Press this button to go back to previous track on USB &
Bluetooth signal.
5. Next: Press this button to go to next track on USB & Bluetooth.
6. Headphone output: Connect the headphone here
BLUETOOTH CONNECTION:
To play Bluetooth signal, enable the Bluetooth function on a Bluetooth device like cell phone and set the mixer
to Bluetooth input mode and then search for available Bluetooth devices nearby on cell phone. The Bluetooth
name of the mixer is "MIX500BT". Pair and connect. There is no pairing code.
Note: The MIX500BT is only discoverable when input is set to Bluetooth.
SPECIFICATIONS
Input voltage ...............................................................................................................................12V�� 500mA
Consumption ...............................................................................................................................................6W
BT frequency band ...................................................................................................................2402-2480MHz
Max. RF transmission power ..............................................................................................................2.84dBm
Weight .................................................................................................................................................. 0.55kg
Dimensions .......................................................................................................................165 x 100 x 60mm
MANUAL - MIX500BT
1
2
3
4
1 2 3 4
1 2 3 4 5
DJ350LED
7
5
8
6
9
11
10
12
5
6
3