English; Getting Started; Cleaning And Care - AEG SB24 Série Mode D'emploi

ENGLISH

Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories and
spare parts. They have been designed especially for your product. This product is designed with the environment in
mind. All plastic parts are marked for recycling purposes.
COMPONENTS
A. Spill-proof drinking lid
B. Spill-proof drinking lid with carry handle*
C. Blend bottle
D. Blade assembly
E. On-Off button
Picture page 2-3

GETTING STARTED

1
Before first use: Clean the blender according to the instructions in "Cleaning and Care". Fill the bottle with ingredi-
ents. Caution! Do not exceed the maximum filling volume: 600 ml. Do not mix dough, mashed potatoes, meat
etc.
2
Fasten the blade assembly on the open end of the bottle, by turning it counterclockwise. Caution! The blades and
inserts are very sharp!
3
Place the blender base on a flat, level surface. Plug into a power outlet.
4
Turn the bottle upside down. Push down the bottle into the blender base and rotate it counterclockwise to lock.
Note: When locked, the symbol
tion! To reduce risk of injury, never place the blade assembly on the base without the bottle properly attached.
5
Push and hold the On-Off button to start mixing. The indicator light will illuminate until the On-Off button is
released. Release the On-Off button to stop mixing. Caution! If the motor stalls, turn the blender off immediately,
unplug the appliance and let it cool for at least 10 minutes.
6
When the ingredients are fully mixed: Release the On-Off button to stop mixing. Make sure the motor has stopped
completely, then turn the bottle clockwise to loosen it. Remove the bottle from the blender base. Replace the blade
assembly with the drinking lid.
USING THE COOLING STICK*
The cooling stick cools down and maintains the temperature of your freshly prepared blends.
7
Unscrew the cap of the cooling stick (H) and fill it with tap water until the MAX mark. Screw the cap back on the
cooling stick and place it in the freezer until the water freezes.
8
Screw the frozen cooling stick on the drinking lid with carry handle (A). Attach it on the blend bottle (C).
The cooling stick can be cleaned in a dishwasher.
USING THE THERMO COVER*
9
Thermo cover performance: Keeps liquids at the same temperature longer, whether cold or hot beverages.
Place the bottle into the cover and close the zipper.

CLEANING AND CARE

10
Unplug the appliance. The Tritan plastic bottle and lid are dishwasher-safe. Please wash the blades by hand.
Caution! The blades and inserts are very sharp!
11
Clean the blender base with a damp cloth. Caution! Never immerse the blender base in water! Do not use abrasive
cleaners or scouring pads when cleaning the appliance.
Enjoy your new AEG product!
www.aeg.com
F. Blender base
G. Power cord
H. Cooling stick*
I.
* Certain models only
on the blender assembly should be aligned with on the blender base. Cau-
(*CERTAIN MODELS ONLY)
(*CERTAIN MODELS ONLY)
Thermo cover*
6