Technical Characteristics; Front Panel - Coelbo SPEEDMATIC SET ALT Instructions Pour L'installation Et L'emploi

TECHNICAL CHARACTERISTICS

Power supply voltage
Frequency
Max. current pump 1 (main pump)
Max. Current pump 2 (auxiliary)
Max. operating pressure
Max. set pressure
Protection index
Max. water temperature
Max. environment temp.
Max. flow
* The system has 10 A aM delayed fuses for the auxiliary pumps and another one of 16 A for the general supply. In case of
pumps with another consumption, the suitable fuses should be chosen.

FRONT PANEL

(Fig.9)
- LCD screen. Shows the pressure in working mode.
- MANUAL START-STOP pushbuttons, they are operative only with AUTOMATIC mode disabled
(green led (4) off).
- Pushbutton AUTOMATIC (ON/OFF).
ON: green led bright.
OFF: green led dull (in this case, AUTOMATIC mode is enabled).
- Green led light for MANUAL/AUTOMATIC mode.
- With this pushbutton we can exit or enter MENU.
- With these pushbuttons we can change programming values showed in the LCD screen (1).
- ENTER for saving programmed values. Every pulsation is succeeded by a new field of the
CONFIGURATION MENU. Whenever we want to quit the configuration sequence press MENU (5).
- Led lights:
• LINE green:Electric supply. ON when it is connected.
• FAILURE red: Bright or intermittent depending on type of failure.
• ON P1 yellow: Pump 1 ON.
• ON P2 yellow: Pump 2 ON.
Fig. 9
~1x230 Vca (160÷250 V)
50/60 Hz
10A*(~1x230 Vca)
10 A* (~1x230 Vca)
16 bar
0÷12 bar
IP55
40ºC
0-50ºC
15.000 l/h
EN