Suctioning Water; Cleaning And Maintenance - Parkside PHD 170 B2 Traduction Des Instructions D'origine

to the equipment is not covered by the
guarantee.
Filling/empyting the cleaning agent:
• To use cleaning agent, there must be
cleaning agent in the cleaning agent
container (24).
• To remove the cleaning agent cont-
ainer (24), grip the container from the
side and push it upwards. Now you
can use the lower and lateral guide to
remove the cleaning agent container
from the pressure washer. Remove the
suction hose with the sealing cap (23)
from the opening of the cleaning agent
container. These remain on the pressu-
re washer.
• To reinsert the cleaning agent cont-
ainer (24), proceed in reverse order.
Working instructions for the
standard Vario nozzle: Use the
standard Vario nozzle (25) in low-pressure
operation (turn completely to the right) and
the cleaning agent is automatically sucked
up.
The further you turn the nozzle to the left,
the less cleaning agent is sucked up. How
to switch to high-pressure operation.
Working instructions for the
rotating washing brush: The
rotating washing brush (21) works in low-
pressure operation, the cleaning agent is
automatically sucked up.

Suctioning water

• Irrespective of the water pipe, you can
also use the device (for example, rain
barrel) through the integrated water
suction function. This function must only
be used with a suction hose with a fil-
ter basket.
The device itself must not be immer-
sed in open water sources. There
is a risk of personal injury from an
electric shock.
Do not draw in any water from na-
tural accumulations. There is a risk
of contamination from backwashed
cleaning agent.
1. Connect the suction hose with filter
basket to the water connection cou-
pling (12) and the water connection
(13) on the device.
2. Insert the end with the filter basket into
the water collector (e.g. rain barrel).
Ensure there is a sufficient and reliable
water supply.
Dry running will damage the
device.
3. Remove the jet pipe (3) from the spray
gun (14). Press the switch-on lever (19)
on the spray gun (14) and then turn
the device on.
4. The device begins to suction water and
air can escape.
5. Once the device is free of air, you can
release the switch-on lever (19) on the
spray gun (14). You can connect an
attachment of your choice to the spray
gun (14).
The device should not be higher
than the tap point.
Cleaning and
Maintenance
Pull out the power plug before eve-
ry maintenance operation. This also
includes connecting to the water
supply or trying to eliminate leaks.
There is a risk of electrocution or of
injury from moving parts.
GB IE
27