Mains Connection; Operation - Parkside PHD 170 B2 Traduction Des Instructions D'origine

coupling (12) and the water connec-
tion (13) on the device.
5. Connect to the spray gun (14) by insert-
ing and screwing in the jet pipe (3).
6. If the jet pipe (3) is mounted, connect
either the standard Vario nozzle (25)
or the turbo dirt miller (26) by inserting
into the jet pipe (3). The attachments
snap into place. To remove the attach-
ments, press the side lock (7) on the
front end of the jet pipe (3) and pull the
attachment forwards to disconnect it.
7. Connect the rotating washing brush
(21) directly to the spray gun (14) by
inserting it and tightening (bayonet fit-
ting). It is always used without applying
any pressure. The cleaning function is
produced by the rotational movement
and the flow of water. If there is no
water flow, the washing brush does not
rotate.
If you turn the tip of the standard
Vario nozzle (25) to the left you will
increase the width of the jet. If you
turn the nozzle tip to the right you
will reduce the width of the jet.
The roles of the unit, use the handle
(2) only in conjunction with the
wheels (11). For lifting and carrying
use the carrying handle (2).

Mains connection

The pressure cleaner you have acquired
is already fitted with a mains plug. The
equipment is designed for connection to an
earthed wall socket with a RCD (Residual
Current Device) at 230 V ~ 50 Hz.
Only operate the pressure cleaner
after all the above points have been
observed.
1. Ensure that the pressure cleaner is
turned off by its ON / OFF switch (8).
2. Insert the mains plug into the mains
socket

Operation

Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing firmly and that you
are holding the gun (14) se-
curely, otherwise you could
injure yourself or other
people.
Never operate the pressure cleaner
with a closed water tap. Dry run-
ning will damage the pressure
cleaner!
1. Turn on the water tap entirely.
2. Switch on the pressure cleaner with the
ON / OFF switch (8).
Only ever switch on the pressure clean-
er once you have connected all of the
water pipes and they do not leak.
The motor switches on until the re-
quired pressure has built up. After
the pressure has built up, the motor
switches off.
3. Press the gun (14) starting lever (19).
The nozzle operates by pressure and
the motor switches back on.
Releasing the starting lever (19) causes
the equipment to switch off. The system
remains pressurised.
• The turbo dirt miller (26) with its rota-
ting water jet is particularly suitable for
working with low water consumption.
• The standard Vario nozzle (25) with its
flat jet is particularly suitable for surfa-
ce cleaning.
If you turn the nozzle tip to the left you
will increase the pressure. If you turn
the nozzle tip to the right you will re-
duce the pressure.
GB IE
25