English
TAB 2
5. Use the letters L, C, R, LR, or RR marked on the
speaker end of each cable to verify which speaker
it connects to.
6. Connect this end to your speaker as follows.
For a Jewel Cube
®
speaker:
a. Hold the plug so the small key is on top.
b. Insert the plug firmly into the connector on the
rear of the speaker.
c. Repeat this process with the remaining four
cables.
Key
R
TAB 3
TAB 4
TAB 5
TAB 6
C
OMPLETE
For a Direct/Reflecting
a. Press the tab on the rear of the speaker to
expose the two connectors.
b. Insert the wire that has a red band into the red
connector marked +.
c. Insert the other wire into the connector that is
marked –.
d. Release the connector tab.
e. Repeat this process with the remaining four
cables.
Tab
Red +
Red R
3
7. Continue with
on the next page to begin
connecting the media center.
TAB 7
TAB 8
S
C
YSTEM
ONNECTIONS
®
speaker:
15