Using The Device (7350, 7300); Control Elements - Dometic FanTastic Vent 7350 Instructions De Montage Et De Service

Using the device (7350, 7300)

➤ If the roof is thinner than 25 mm, use the spacer (accessory).
➤ Install the inner frame (fig. b, page 8).
➤ After installing, check again the fan works properly.
➤ If necessary, enter the new vehicle height and weight in the vehicle documents.
7.1 Mounting the holder for the remote control
(7350, 7300)
➤ Fasten the holder of the remote control onto the wall with two screws (fig. c,
page 9).
8 Using the device (7350, 7300)
8.1

Control elements

The remote control has the following buttons and displays:
No. in
fig. d,
page 10
1
2
3
4
5
6
7
8
The fan control confirms commands from the remote control with a beep. If a single
beep is not emitted, the command has not been received.
A double beep indicates that a command is not permitted.
18
Description
To switch the fan on/off
"Auto" LED
To set the temperature
To set the outlet/inlet air (for 7350 and 6350 only)
"Rain Sensor Off" LED
Press briefly: To open/close the cover hood
Press for 3 seconds: To switch the rain sensor on/off
To set the fan speed
"Manual" LED
FanTastic Vent
EN