Getting Started - AEG KAM400 Mode D'emploi

ENGLISH
Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories and
spare parts. They have been designed especially for your product. This product is designed with the environment in
mind. All plastic parts are marked for recycling purposes.
COMPONENTS
. Coffee grinder bean container
A
. Finess setting
B
. Grinder channel
C
. Swivel filter
D
. Coffee jug and jug lid
E
. Coated warming plate
F
. Rotatable base
G
. Swivel filter open
H
. Fresh water tank
I
Picture page 2-5

GETTING STARTED

1
Prior to preparing coffee for the first time, perform one brew with water only. Fill the fresh water tank up to the top
cup marking with cold water. Close the lid. Press the ON/OFF button
through into the coffee jug. When brewing is finished, empty the coffee jug.
2
Fill the water tank with clear, cold tap water. There are cup markings on the coffee jug for measuring the required quantity.
Close the lid of the fresh water tank.
3
Swing out the swivel filter. Insert a filter paper. Swing the swivel filter back again.
4
Place the jug with lid on the warming plate.
5
Place coffee beans in the bean container. The coffee grinder has a container which keeps the beans constantly aroma fresh.
Fill the container to the top and fasten the lid firmly. The bean container holds approximately 250g of coffee beans.
6
Turn the Finess settings to the desired position. Change the size of coffee ground to suit the strength of roast. It is recom-
mended to begin with a medium setting which is suitable for the types of coffee that are usually commercially available.
7
Connect to the main supply. The display will flash the initial time showing: 12:00.
8
Set the time. The appliance has a timer, to set time and pre-programming the start time to 24 hours in advance: (Auto func-
tion).Set hours with the Hours button
9
The appliance will start a 40 minutes keep warm function automatically when brewing. During keep warm function press
ON/OFF button to cancel it. The keep warm function
to stand by condition.
OPERATING INSTRUCTIONS
10
It is possible to make coffee using ready ground coffee either immediately, or by pre -programming the start time, (Auto
function). For preparation using ready ground coffee, the settings for coffee strength, number of cups and aroma setting will
have no effect.
Pour in water in the fresh water tank.
11
Swing out the swivel filter. Insert a filter paper. Add ground coffee. Swing swivel filter back.
12
To make coffee instantaneously. Place the coffee jug on the warming plate. Press the ON/OFF button
procedure will start.
13
Making coffee by pre-programming the start time, (Auto function). Long press the Program button. Set the desired start
time using the Hour
14
Short press Program button
"Auto" will show up on the display. Press Program button
the start time will not be changed.
15
When reached the pre-set time, the machine will start brewing coffee.
16
Prepare coffee with beans either immediately or by pre-programming the start time, (Auto function). For preparing
coffee with beans, set number of cups, coffee strength and where required the aroma setting. Place the coffee beans in the
bean container. Close the lid firmly.
17
Preparing coffee instantaneously. Pour in water in the fresh water tank. Swing out swivel filter, insert filter paper.
18
Place the jug on the warming plate. Set Aroma setting at 2 or 4 cups. Press the Aroma button
8
. Set minutes with the Min button
and Minute button.
after finishing the program setup, to activate the Auto function. When activated,
. Display
J
. Button for number of cups
K
. Button for coffee strength
L
. Button for programme activation
M
. Clock setting button, hour
N
. Clock setting button, minute
O
. On/Off button
P
. Pre-ground coffee powder button
Q
. Aroma button
R
to switch on the appliance. Allow the water to flow
.
will automatically stop after 40 minutes and the appliance turns
again to cancel the Auto function. If once pre-programmed,
. The brewing
.
www.aeg.com