Getting Started - AEG PERFECTAROMA KF7500 Mode D'emploi

Getting started

1. Setting/changing time. Plug in the
GB
machine, the display will flash the
initial time showing: 12:00. Press the
HOUR and MIN button to set the
required time. Time can be changed
at any time, even under program
mode. Simply press the HOUR and
MIN button, the time changes at once.
Note: if you unplug the machine, the
time needs so be set again.
4. Insert a size 1x4 paper filter in
the filter holder and fill it with
ground coffee. There is a gauge for
recommended number of spoons of
coffee next to the water gauge. For
average strong coffee 1 measuring
spoon (approx. 6-7 g) per cup is
sufficient. Close the water tank lid and
place the jug back (complete with lid).
2. Place the machine on a flat surface.
When starting the machine for the
first time, fill the tank with cold water.
Start the machine with the ON/OFF
switch. Let a full tank of water pass
through the machine once or twice to
clean it, without using a paper filter or
coffee.
5. Setting delay time. Press the
PROGRAM button, the display flashes.
Set hours by pressing the HOUR
button. Then set minutes by pressing
the MIN button. Press the PROGRAM
button again to confirm. The display
will go back to show the current time
after 5 seconds.
3. Making coffee: open the lid and fill
the water tank with fresh cold water
up to the desired level. There is a
water level indicator on the water
tank and on the coffee jug. (The
machine must not be used with
empty tank!)
6. Changing the delay time. Press
and hold the PROGRAM button for 3
seconds. The display flashes and the
PROGRAM button light turns off. Set
hours by pressing the HOUR button.
Then set minutes by pressing the MIN
button. Press the PROGRAM button
again to confirm.
D
GR
NL
F
GB
15